An overview of Bearing clips.

Bearing as a very important part of the machine parts, it needs the bearing clamp for solid connection limit in the assembly process, after continuous research and development and update, the current bearing clamp has become very ideal to meet the needs of the public.

The bearing clamp is a part comprising a clamp, a curved undertaking part and a chuck, one of which is a long strip clamp connected with the chuck through the curved undertaking part.

Bearing clamp features:

The process is simple, the installation is convenient, the structural strength is high, the tensile limit effect is good.

There are two cleaning methods for bearing clamps and bearings

First, hot oil cleaning method due to the use of a long time, soft dry oil or anti-rust paste hardened bearings, should be immersed in 100-200 ℃ hot oil, clamp the bearing with pliers, brush clean the oil on the bearing. Soft dry oil or anti-rust paste is heated to 100-200 ℃ to melt, it is easy to wash out from the gap in the bearing. Sometimes just shake the bearing in the oil several times. Oil can also flow through the crevices.

When cleaning the radial spherical bearings of the old motor or imported motor, the ball, the bead frame, the inner ring should be turned out of the outer ring and then immersed in hot oil, and the roller, the bead frame, the inner ring and the outer ring should also be removed when cleaning the short cylindrical roller bearings.

When cleaning the hot oil, the temperature of the oil should not exceed 20℃. If the direct heating with an open flame, attention should be paid to prevent the oil from burning, the bearing should be suspended in the oil pan, the bottom will cause overheating and reduce the hardness.

Second, the general cleaning method to soak the bearing in kerosene 5-10 minutes, hold the inner ring with one hand, the other hand to turn the outer ring, the dry oil or rust cream on the bearing will fall down.

Then put the bearing into the cleaner kerosene, wash with a soft brush, wash the oil in the ball and the gap, and then put it in the gasoline to clean once, and put it on a clean paper. When cleaning the radial spherical ball bearings and short cylindrical roller bearings, the ball, the bead holder, the inner ring and the outer ring should be removed for cleaning.

The cleaning of the bearings installed on the shaft mainly depends on the method of spraying oil or oil gun injection, and the oil that is easy to clean off is first used kerosene and then gasoline; The oil that is difficult to clean off, first wash with 100-200 ℃ hot oil or oil gun injection, and then clean with gasoline.

Be sure not to scrape the bearing with sharp tools: hard grease or rust, so as not to damage the finish of the bearing rolling body and groove ring parts, clean the bearing with a clean cloth dry.